Hi,
I have a problem that I think is not the ET software problem, but more a Windows 7 problem.
If I turn on the TV that I have the pc connected to so I can use it to view the music videos,
if it's turned on after ET touch is open & running, the moment the TV screen flicks on it will send like a pulse that makes my primary PC monitor flicker off & on, and then ETouch would get out of full screen & go to minimize in the top left corner of my main PC monitor. Also it wont show videos on the 2nd screen, 2nd screen will show extended desktop Windows logo. I have to exit E Touch & start E Touch again and everything continues normally. Also if I cycle between example hdmi 1 to TV and back to HDMI 1 the moment the tv screen open into HDMI 1, this issue will repeat itself.
Any suggestions?
Firstly if you have another TV try your current setup with the other TV.
It might be a faulty TV on last legs
Second if you have other hdmi cables try those.
Thirdly check graphic card
Fourth check power supply might be on way out
FIfth check hard drive might be on way out if old
You might try the hdmi first save carrying tvs
Think you need to have the TV on first for windows 7 to use it properly with etouch.
Thanks guys for your reactions, I was using for a long time SK jukebox with Win XP os, also a jukebox software called 3pm, also W XP and never did this, I tried another PC with SK jukebox with W7 and it will also send a pulse through the system, and now I realize if W7 is just desktop with no aplications, it will also send that pulse when TV turns on. Tried changing cables, and grphx card, but no solution. Will try another TV later on.
Check this out. I had the same issue using a hdmi switch.
http://monitordetectkiller.com
Bought one and never looked back. I tried doing the pin 19 trick but it didn't work for me.